User manual

WWW.FOSCAM.COM FI8918W User Manual
3.19 Log
The log record shows who accessed the camera (Figure 3.38).
Figure 3.38
3.20 Back
This will take you back to the video window.
4 APPENDIX
4.1 Frequently Asked Questions
NOTE: Always verify network connections are working by checking the status of the indicators
on the network server, hub, exchange and network card.
4.1.1 I have forgotten the administrator username and/or password
To reset the administrator username and password, press and hold down the RESET BUTTON
for 15 seconds. Releasing the reset button will restore the factory default settings for username
and password. You must power on the camera before reset.
Default administrator username: admin
Default administrator password: No password
4.1.2 Subnet doesn’t match, dbclick to change
If IP Camera Tool shows the error “Subnet doesn’t match, dbclick to change!”, select Obtain IP
from DHCP server. (Figure 2.4)
If this error still exists after obtain IP from DHCP server, check your local area connection of your
computer and verify the subnet and gateway of the camera which should be the same subnet of
your computer. (Figure 2.5)
Shenzhen Foscam Intelligent Technology Co., Limited
Tel: [phone] Fax: [phone]
41