User's Manual
Table Of Contents
- 1 WELCOME
- 2 SOFTWARE OPERATION
- 3 How to do settings in For Administrator
- 3.1 Alias Settings
- 3.2 Date & Time Settings
- 3.3 User Settings
- 3.4 Multi-Device Settings
- 3.5 Basic Network Settings
- 3.6 Wireless LAN Settings
- 3.7 ADSL Settings
- 3.8 UPnP Settings
- 3.9 DDNS Service Settings
- 3.10 Mail Service Settings
- 3.11 FTP Service Settings
- 3.12 Alarm Service Settings
- 3.13 PTZ Settings
- 3.14 Upgrade Device Firmware
- 3.15 Backup & Restore Settings
- 3.16 Restore Factory Settings
- 3.17 Reboot Device
- 3.18 Log
- 4 APPENDIX
- 4.1 Frequently Asked Questions
- 4.1.1 I have forgotten the administrator username and/or password
- 4.1.2 Subnet doesn’t match, dbclick to change
- 4.1.3 No Pictures Problems
- 4.1.4 Can’t access IP camera in internet
- 4.1.5 IP Camera Tool could not find camera’s IP
- 4.1.6 UPnP always failed
- 4.1.7 Couldn’t find the shortcut on desktop after install IP camera tool
- 4.1.8 I can’t change the record path
- 4.1.9 I can’t find multi-device settings and record icon
- 4.1.10 Camera can not connect wireless
- 4.1.11 I can’t see other cameras which in multi-device when remote access
- 4.1.12 Only see black screen or unreasonable code when remote login
- 4.2 Default Parameters
- 4.3 Specifications
- 4.1 Frequently Asked Questions
- 5 OBTAINING TECHNICAL SUPPORT
- 6 changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
IPCAM User Manual
If you click here , the camera will horizontally&vertically rotate and
then stop at the center
Ture off IR light
Turn on IR light
Prepoint set
Figure 2.19
: Click this icon; camera will rotate up and down. Click to stop.
: Click this icon; camera will rotate left and right. Click to stop.
: Click this icon, all the IR lights will turn on. Click to turn off them.
Flip & Mirror: You can choose flip or mirror if you set up the camera in a special position.
Mode: There are three modes. (50HZ, 60HZ and outdoor)
Brightness and Contrast are also used to adjust the quality of the video.
Preset: You can set prepoint through this function,that is, click the button “set”. According to the
set you can return here from anywhere when you click the button “go”.
For Firefox, Google chrome and safari
Click Live Video. You can see the difference from IE and Firefox.
In IE, there is a button for default all the settings. In Firefox, the snapshot button is under for
operator. Add the other two function; refresh video and refresh parameters. (Figure 2.20)
www.foscam.com
- 16 -