User's Manual
Table Of Contents
- 1 WELCOME
- 2 SOFTWARE OPERATION
- 3 How to do settings in For Administrator
- 3.1 Alias Settings
- 3.2 Date & Time Settings
- 3.3 User Settings
- 3.4 Multi-Device Settings
- 3.5 Basic Network Settings
- 3.6 Wireless LAN Settings
- 3.7 ADSL Settings
- 3.8 UPnP Settings
- 3.9 DDNS Service Settings
- 3.10 Mail Service Settings
- 3.11 FTP Service Settings
- 3.12 Alarm Service Settings
- 3.13 PTZ Settings
- 3.14 Upgrade Device Firmware
- 3.15 Backup & Restore Settings
- 3.16 Restore Factory Settings
- 3.17 Reboot Device
- 3.18 Log
- 4 APPENDIX
- 4.1 Frequently Asked Questions
- 4.1.1 I have forgotten the administrator username and/or password
- 4.1.2 Subnet doesn’t match, dbclick to change
- 4.1.3 No Pictures Problems
- 4.1.4 Can’t access IP camera in internet
- 4.1.5 IP Camera Tool could not find camera’s IP
- 4.1.6 UPnP always failed
- 4.1.7 Couldn’t find the shortcut on desktop after install IP camera tool
- 4.1.8 I can’t change the record path
- 4.1.9 I can’t find multi-device settings and record icon
- 4.1.10 Camera can not connect wireless
- 4.1.11 I can’t see other cameras which in multi-device when remote access
- 4.1.12 Only see black screen or unreasonable code when remote login
- 4.2 Default Parameters
- 4.3 Specifications
- 4.1 Frequently Asked Questions
- 5 OBTAINING TECHNICAL SUPPORT
- 6 changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
IPCAM User Manual
check it and try again
6) The receiver is denied by the server. Maybe because of the anti-spam privacy of the server
7) The message is denied by the server. Maybe because of the anti-spam privacy of the server
8) The server does not support the authentication mode used by the device
Report Internet IP by Mail—If choose it, you will receive emails which contain internet IP. When
camera power on or Internet IP changed, it will send the internet IP by mail. (For example:
IPCAM's urls is http://119.123.207.96:8068). Make sure the port is map to the router correctly.
3.11 FTP Service Settings
If you want upload images to your FTP server. You can set FTP Service Settings.
Figure 3.20
Figure 3.21
FTP server: If your FTP server is set up in LAN, you can set as Figure 3.20
If you have a FTP server which you can access in internet, you can set as Figure 3.21
FTP Port: Usually the port is 21
FTP Upload Folder: Make sure that the folder you plan to store images exists. For camera
couldn’t create the folder itself. Also, the folder must be erasable.
FTP Mode: It supports standard (POST) mode and passive (PASV) mode
Upload Image Now: It will upload images when you choose the checkbox. Here Upload
Interval refers to the time between the current image and the next image.
www.foscam.com
- 28 -