User's Manual
Table Of Contents
- 1 WELCOME
- 2 SOFTWARE OPERATION
- 3 How to do settings in For Administrator
- 3.1 Alias Settings
- 3.2 Date & Time Settings
- 3.3 User Settings
- 3.4 Multi-Device Settings
- 3.5 Basic Network Settings
- 3.6 Wireless LAN Settings
- 3.7 ADSL Settings
- 3.8 UPnP Settings
- 3.9 DDNS Service Settings
- 3.10 Mail Service Settings
- 3.11 FTP Service Settings
- 3.12 Alarm Service Settings
- 3.13 PTZ Settings
- 3.14 Upgrade Device Firmware
- 3.15 Backup & Restore Settings
- 3.16 Restore Factory Settings
- 3.17 Reboot Device
- 3.18 Log
- 4 APPENDIX
- 4.1 Frequently Asked Questions
- 4.1.1 I have forgotten the administrator username and/or password
- 4.1.2 Subnet doesn’t match, dbclick to change
- 4.1.3 No Pictures Problems
- 4.1.4 Can’t access IP camera in internet
- 4.1.5 IP Camera Tool could not find camera’s IP
- 4.1.6 UPnP always failed
- 4.1.7 Couldn’t find the shortcut on desktop after install IP camera tool
- 4.1.8 I can’t change the record path
- 4.1.9 I can’t find multi-device settings and record icon
- 4.1.10 Camera can not connect wireless
- 4.1.11 I can’t see other cameras which in multi-device when remote access
- 4.1.12 Only see black screen or unreasonable code when remote login
- 4.2 Default Parameters
- 4.3 Specifications
- 4.1 Frequently Asked Questions
- 5 OBTAINING TECHNICAL SUPPORT
- 6 changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
IPCAM User Manual
Click Submit after these settings. Then click Test. You will see the following picture.
Figure 3.22
If it prompts error information as follows.
1) Can not connect to the server. Please check FTP Server is correct or not.
2) Network Error. Please try later.
3) Server Error.
4) Incorrect user or password. Please check the username and password is correct or not.
5) Can not access the folder. Please be sure the folder exists and your account is authorized
6) Error in PASV mode. Please be sure the server support PASV mode
7) Error in PORT mode. PASV mode should be selected if the device is behind a NAT
8) Can not upload file. Please be sure your account is authorized
Please check if parameters you filled in are correct or not. The format of image is like
00606E8C1930(sarah)_0_20100728114350_25.jpg
Please check if your FTP server supports this format of file name
3.12 Alarm Service Settings
If you enable Motion Detect Armed. It will send mail alerts and upload images when motion
trigger.
There will not be so much false alarm
when light changes
Choose it
If the number is bigger and the
sensibilityis higher
Figure 3.23
www.foscam.com
- 29 -