User's Manual
Table Of Contents
- 1 WELCOME
- 2 SOFTWARE OPERATION
- 3 How to do settings in For Administrator
- 3.1 Alias Settings
- 3.2 Date & Time Settings
- 3.3 User Settings
- 3.4 Multi-Device Settings
- 3.5 Basic Network Settings
- 3.6 Wireless LAN Settings
- 3.7 ADSL Settings
- 3.8 UPnP Settings
- 3.9 DDNS Service Settings
- 3.10 Mail Service Settings
- 3.11 FTP Service Settings
- 3.12 Alarm Service Settings
- 3.13 PTZ Settings
- 3.14 Upgrade Device Firmware
- 3.15 Backup & Restore Settings
- 3.16 Restore Factory Settings
- 3.17 Reboot Device
- 3.18 Log
- 4 APPENDIX
- 4.1 Frequently Asked Questions
- 4.1.1 I have forgotten the administrator username and/or password
- 4.1.2 Subnet doesn’t match, dbclick to change
- 4.1.3 No Pictures Problems
- 4.1.4 Can’t access IP camera in internet
- 4.1.5 IP Camera Tool could not find camera’s IP
- 4.1.6 UPnP always failed
- 4.1.7 Couldn’t find the shortcut on desktop after install IP camera tool
- 4.1.8 I can’t change the record path
- 4.1.9 I can’t find multi-device settings and record icon
- 4.1.10 Camera can not connect wireless
- 4.1.11 I can’t see other cameras which in multi-device when remote access
- 4.1.12 Only see black screen or unreasonable code when remote login
- 4.2 Default Parameters
- 4.3 Specifications
- 4.1 Frequently Asked Questions
- 5 OBTAINING TECHNICAL SUPPORT
- 6 changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
IPCAM User Manual
Figure 4.1
If you allow the activeX running, but still could not see living video, only a red cross in the center
of the video. There is a yellow light in the device status.
Not green. Please change another port number to try. Don’t use port 80, use port 85, 8005.etc.
Figure 4.2
NOTE: Make sure that your firewall or anti-virus software does not block the camera or activeX.
If you could not see video, please shut down firewall or anti-virus software to try again.
4.1.4 Can’t access IP camera in internet
There are some reasons:
1 ActiveX controller is not installed correctly (see more details: Figure 2.10~Figure 2.12).
www.foscam.com
- 35 -