User's Manual
Table Of Contents
- 1 WELCOME
- 2 SOFTWARE OPERATION
- 3 How to do settings in For Administrator
- 3.1 Alias Settings
- 3.2 Date & Time Settings
- 3.3 User Settings
- 3.4 Multi-Device Settings
- 3.5 Basic Network Settings
- 3.6 Wireless LAN Settings
- 3.7 ADSL Settings
- 3.8 UPnP Settings
- 3.9 DDNS Service Settings
- 3.10 Mail Service Settings
- 3.11 FTP Service Settings
- 3.12 Alarm Service Settings
- 3.13 PTZ Settings
- 3.14 Upgrade Device Firmware
- 3.15 Backup & Restore Settings
- 3.16 Restore Factory Settings
- 3.17 Reboot Device
- 3.18 Log
- 4 APPENDIX
- 4.1 Frequently Asked Questions
- 4.1.1 I have forgotten the administrator username and/or password
- 4.1.2 Subnet doesn’t match, dbclick to change
- 4.1.3 No Pictures Problems
- 4.1.4 Can’t access IP camera in internet
- 4.1.5 IP Camera Tool could not find camera’s IP
- 4.1.6 UPnP always failed
- 4.1.7 Couldn’t find the shortcut on desktop after install IP camera tool
- 4.1.8 I can’t change the record path
- 4.1.9 I can’t find multi-device settings and record icon
- 4.1.10 Camera can not connect wireless
- 4.1.11 I can’t see other cameras which in multi-device when remote access
- 4.1.12 Only see black screen or unreasonable code when remote login
- 4.2 Default Parameters
- 4.3 Specifications
- 4.1 Frequently Asked Questions
- 5 OBTAINING TECHNICAL SUPPORT
- 6 changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment
IPCAM User Manual
6 changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate the equipment
7 This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the
following measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for
help.
Power adapter
Manufacturer: Shenzhen Yingyuan Electronics Co.,Ltd
MODEL: SAW - 0502000
INPUT: 100-240V 50-60Hz 0.5 A
OUTPUT: 5V - 2000mA
The antennas used for this transmitter as shown in this filing must be installed to provide
a separation distance of at least 20 cm from all persons and must not be co-located or
operating in conjunction with any other antenna or transmitter
www.foscam.com
- 39 -