User's Manual

ww.foscam.co

Shenzhen

Foscam

Intelligent

Technology

Co.,

Limited

Tel:

755

2674

5668

Fax:

755

2674

5168

restarted. Just wait for around 1 minute, the camera will get wireless connection, and the LAN IP

of the camera will be showed again on the window of the IP Cam Tool. You have done wireless

connection of the camera successfully. If the camera has a dynamic IP, after the wireless settings,

the IP will be changed.

If fail to make WiFi connection, please refer to seller or us for help.

3.7.2 WPS (Wi-Fi Protected Set-up)

Step 01) Please press and hold the RESET button for four seconds. .

Step 02) Press the WPS button on your router within 6 0 seconds. The WPS button is usually

on the back or side of your router. On some routers, you may need to log in to the web interface

and click on a n on-screen button to activate the WPS feature. If you are not sure where the WPS

buttons is on your router, please refer to your router’s User Manual.

The camera will automatically create a secure wireless connection to your router. If you have

plugged in the network cable, please plug it out. While connecting, the green network light will

blink quickly and the wireless settings will take e ffect. The IP Camera Tool will search the

camera’s LAN IP. Make sure the PC and the camera share the same subnet.

1 During the WPS Settings, you must press the Reset button only for four seconds, or else, the

camera may be reset back to factory default settings if you press and hold on the reset button

above 10 seconds.

2 The security mode of router cannot be WEP, or else the WPS settings may be failed.

Note

Reset Button