User's Manual

ww.foscam.co

Shenzhen

Foscam

Intelligent

Technology

Co.,

Limited

Tel:

755

2674

5668

Fax:

755

2674

5168

Another way to change the HTTP port no.

Step 1:

Open the IP Camera Tool, select the camera you would like to change the port of, right

click on the IP address, and click on ”Network Configuration”, this brings up the network

configuration box as shown in Figure 4.35 and 4.36.

Figure 4.35

Figure 4.36

Step 2:

Enter the username and password of the Administrator (default username is admin with

a blank password), and click “OK” to apply changes.

Step 3:

Wait around 10 seconds, you’ll see that the camera’s LAN IP address has changed. In

our example it was changed to 2000, so we see http://192.168.8.102:2000 in IP Camera Tool.

Also, the LAN IP address is now fixed at a static IP address of http://192.168.8.102:2000. This IP

address will not change even if the camera is powered off and back on, the camera will remain

on this LAN IP address. This is very important that a static LAN IP address is set, or you may

Select which camera

you’d like to change the

port for, and right click

Modify the Http Port.

Enter the Username and

assword

click O