User's Manual

www.foscam.com
Shenzhen Foscam Intelligent Technology Co., Limited
Tel: [phone] Fax: [phone]
66
4.7.3 Start-Up Options
Here section will allow you to set the stop position after the camera reboots.
It supports three modes: No self test, Goto home position and Goto preset point.
No self test: When rebooting, the camera will not pan / tilt.
Goto home position: When rebooting, the camera will pa Providing Central Management Software to manage or
monitor multi-cameras n / tilt and stops at center.
Goto Preset point: Select one preset position and save it. When rebooting, the camera will pan/ tilt and stops at the
preset position you have set.
Figure 4.74
4.8 Firewall
This section explains how to control the access permission by checking the client PC’s IP addresses. It is composed of
the following columns: Block access from these IP addresses and Only allow access from these IP addresses.
Figure 4.75
Enable firewall, If you select Only allow access from these IP addresses and fill in 8 IP addresses at most, only those
clients whose IP addresses listed in the Only allow access from these IP addresses can access the Network Camera. If
you select Block access from these IP addresses, only those clients whose IP addresses are in the IP list cannot access
the Network Camera.
Click Save to take effect.