User's Manual

www.foscam.com
Shenzhen Foscam Intelligent Technology Co., Limited
Tel: [phone] Fax: [phone]
73
factory default administrator username and password. Please power on the camera before reset
Default administrator username: admin
Default administrator password: No password
5.1.4 Camera can not record when I click Record button or I can’t change the
manually record path
When you use Windows7 or Vista, you may be not able to do manually record or change the record path because of the
security settings of computer.
There are two ways to resolve this problem:
Please add the camera as a trusted site to resolve this issue. The steps are ：
IE browserToolInternet PropertiesSecurityTrusted sitesSitesAdd
Open IE browser, then right click, select “Run as administrator”
5.1.5 Subnet doesn’t match
Check whether your ipcamera in the same subnet of your computer. The step is Control PanelNetwork
ConnectionsDbclick Local Area Connections  Choose GeneralProperties.Check subnet mask, IP address and
gateways. When you set IP address please make sure they are in the same subnet. Otherwise you can't access camera.
5.1.6 No Pictures Problems
The video streaming is transmitted by the ActiveX controller. If ActiveX controller isn’t installed correctly you will see
no video image. You can resolve this problem by this way:
Download ActiveX controller and set the safety property of IE in the PC when you view it first time: IE
browserToolInternet ProperSecurityCustom LevelActiveX control and Plug-ins. Three options of front
should be set to be “Enable”, The ActiveX programs read by the computer will be stored. As follows:
Enable: Download unsigned ActiveX controls
Enable: Initialize and script ActiveX controls not marked as safe
Enable: Run ActiveX controls and plug-ins