User's Manual

www.foscam.com

11Shenzhen

Shenzhen

Foscam

Intelligent

Technology

Co.,

Limited

Tel:

755

2674

5668

Fax:

755

2674

5168

All cameras have the default HTTP port of 88. For example, if the LAN IP link of the camera is

http://192.168.8.102:88

, this means that the camera’s HTTP port is 88. You can change port 88 to another port

if you’d like such as 2000 or 8090, which will not be conflict with other existing ports like 25, 21,10000.Here you

can set the port no. between 1 and 65535.

Change the default http no.88 to another one.

How to assign a different HTTP Port No. and fixed the LAN IP of the camera by the IP

Camera Tool

？

Step 1: Open the IP Camera Tool, select the camera you would like to change the port of, right click on the IP

address, and click on ”Network Configuration”, this brings up the network configuration box as shown in Figure

2.8 and 2.9.

Figure 2.8

Figure 2.9

Step 2: Enter the username and password of the Administrator (default username is admin with a blank

password), and click “OK” to apply changes.

Step 3: Wait around 10 seconds, you’ll see that the camera’s LAN IP address has changed. In our example it

was changed to 2000, so we see http://192.168.8.102:2000

in IP Camera Tool. Also, the LAN IP address is

now fixed at a static IP address of http://192.168.8.102:2000

. This IP address will not change even if the

camera is powered off and back on, the camera will remain on this LAN IP address. This is very important that

a static LAN IP address is set, or you may have problems later with remote access and seeing the camera

remotely if the camera loses power and reconnects on a different LAN IP address. Make sure you set a static

Select w hich camera

you’d like to change the

port for , and right click

Modify the Http Port.

Enter the Username and

assword

click OK.