User's Manual

www.foscam.com
72Shenzhen
Shenzhen
Foscam
Foscam
Intelligent
Intelligent
Technology
Technology
Co.,
Co.,
Limited
Limited
Tel:
Tel:
86
86
755
755
2674
2674
5668
5668
Fax:
Fax:
86
86
755
755
2674
2674
5168
5168
72
Enable firewall, If you select Only allow access from these IP addresses and fill in 8 IP addresses at most, only
those clients whose IP addresses listed in the Only allow access from these IP addresses can access the
Network Camera. If you select Block access from these IP addresses, only those clients whose IP
addresses are in the IP list cannot access the Network Camera.
Click Save to take effect.
4.9 System
In this panel, you can backup/restore your camera settings, upgrade the firmware to the latest version, restore
the camera to default settings and reboot the device.
4.10.1 Back-up& Restore
Click Backup to save all the parameters you have set. These parameters will be stored in a bin file for future
use.
Click Browse and select the parameters file you have stored, then click Submit to restore the restore the
parameters.
Figure 4.73
4.10.2 System Upgrade
Your current firmware version will be displayed on your screen. You may go to the Device Status

Device
Information Page to check for the latest firmware versions available.
Click Browse, choose the correct bin file and then click System upgrade. Make sure you have unplugged the
SD card.