User's Manual

www.foscam.com
Shenzhen Foscam Intelligent Technology Co., Limited
Tel: [phone] Fax: [phone]
4
1.LAN: 10/100 Mbps RJ-45 port for wired connection
2.Power: DC 5V/2A Power supply
3.Network Light: The LED will blink slowly in wired connection, blink two times faster in wireless
connection
4.Power Light: If the power supply works fine, the light will turn on
5.WPS: Push the WPS button on the camera and wireless router in 1 minutes, the camera will connect
the wireless router automatically, in WPS process, the Network Light will blink very fast
6. SD card Slot: Supports up to 32GB SD card for storing the video
7.Audio Output: This jack is used to plug an external speaker
8.Audio Input: This jack is used to plug an external microphone
9.Antenna: Used to connect external wireless antenna
Bottom View
Figure 1.4
1.Mounting Port: Port for mounting bracket
2.Reset Button: Push and hold for more than 5 seconds to set the camera to factory default
3.Product Label: There are P2P QR code, MAC address, UID, DDNS URL, default username and
password on the label
4.WI-FI Module Label: There is WI-FI MAC address and serial number of the WI-FI module on the label
5.SN Label: There is serial number of the camera on the label
6 The different features between the models involved
1.Mounting Port
2.Reset Button
3.Product Label
4.WI-FI Module Label
5.SN Label