User's Manual

www.foscam.com
Shenzhen Foscam Intelligent Technology Co., Limited
Tel: [phone] Fax: [phone]
74
manage or monitor multi-cameras n / tilt and stops at center.
Goto Preset point: Select one preset position and save it. When rebooting, the camera will pan/ tilt and stops
at the preset position you have set.
Figure 4.79
4.8 Firewall
This section explains how to control the access permission by checking the client PC’s IP addresses. It is
composed of the following columns: Block access from these IP addresses and Only allow access from
these IP addresses.
Figure 4.80
Enable firewall, If you select Only allow access from these IP addresses and fill in 8 IP addresses at most, only
those clients whose IP addresses listed in the Only allow access from these IP addresses can access the
Network Camera. If you select Block access from these IP addresses, only those clients whose IP
addresses are in the IP list cannot access the Network Camera.
Click Save to take effect.
4.9 System
In this panel, you can backup/restore your camera settings, upgrade the firmware to the latest version, restore
the camera to default settings and reboot the device.