Quick Start Guide
Powering On / O
To power on/o the remote controller, rst press the power button
once, then press again and hold the power button for 3 seconds.
To check the battery level when the battery is o, short press the power
button, then the battery level indicator will display the current battery
level. Refer to the following table for more information about the
battery level indicator states:
Remote Controller Status Indicator
LED1 LED2 LED3 LED4 The Current Power
75%~100%
50%~75%
25%~50%
0%~25%
Using the Remote Controller
Auto Take-o / Land
Press the take-o / land button on the right side of the remote
controller for automatic take-o or landing.
One Key
Take on-o
Controlling the Aircraft
Two pre-programmed modes (Mode 1, Mode 2) are available as shown in
the illustration below.
12