Quick Start Guide

Using the Remote Controller
Optimal signal transmission between the remote controller and the
aircraft can be achieved when the antennas and the aircraft are
positioned as shown below. Adjust the antenna positions to ensure the
aircraft is always within the best reception range.
Optimum Transmission Zone
forward and down to y backward. The larger the amount of deection, the
faster the aircraft will move forward / backward. If the stick stays in the neutral
position, the aircraft will not move forward / backward.
The roll channel controls the aircraft’s roll. Move the right stick left to y left
and right to y right. The larger the deection amount, the faster the aircraft
will move left / right. If the stick stays in the neutral position, the aircraft will
not move sideways.
Auto Return to Home (RTH)
Auto RTH works only when the GPS position of the home point is
acquired. To activate auto RTH, press the Return to Home (RTH) button
once. The aircraft will then return to its last updated home point
position. During the RTH process, manual adjustments to the aircraft
can be made with the control sticks.
Controlling the Camera Tilt
The camera dial wheel on the remote controller allows consistent
adjustments on the camera tilt angle.
Taking Pictures / Videos
Press and hold the shutter / record button to switch between photo
mode and video mode. Short press the shutter / record button to take
a photo when in photo mode or record a video when in video mode.
14