Troubleshooting Guide

3.3 Cable layout and connector assembly

Connect cables to the booster’s ports after installing and fixing outside and inside

antennas.Steps as below:

（1）Open the cable package and make it bend naturally and smoothly.

（2） Keep horizontal cables straight and fasten them with a fixing clip every 1 to 1.5

meters.

（3）The cable should be bent naturally and smoothly to avoid cable damage caused by

strong pulling.

（4）RF cables should be separated from power cables; If the site condition are limited,

installing RF cables and power cables together may affect product performance.

（5）Tighten all cable connections to ensure a good contact.

（6）Offer waterproof treatment to the exposed cable ends to avoid oxidation.

（7）Finish the cable layout

At last, plug the Power Supply into wall outlet and enjoy

your boosted cell signal!

The Specification of Boosters’Ports:

Port Name Port Description

DC12V 12V Input

OUTDOOR/B

The reception of base station downlink signal, and the

transmission of cell phone uplink signal

INDOOR/MS

The transmissionof base stationdownlink signal, and the reception of cell

phone uplink signal