Data Sheet

http://www.genrace.com
ATTENTION
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users, and
2) This device and its antenna(s) must not be co‐located with any other transmitters except in accordance with
FCC multi‐transmitter product procedures. Referring to the multi‐transmitter policy, multiple transmitter(s)
and module(s) can be operated simultaneously without C2P.
3) For all products market in US, OEM has to limit the Operating Frequency: 902.75MHz~927.25MHz by
supplied firmware programming tool. OEM shall not supply any tool or info to the end‐user regarding to
Regulatory Domain change.
USERS MANUAL OF THE END PRODUCT:
In the user manual of the end product, the end user has to be informed to keep at least 20cm separation with the
antenna while this end product is installed and operated. The end user has to be informed that the FCC radio‐
frequency exposure guidelines for an uncontrolled environment can be satisfied. The end user has to also be
informed that any changes or modifications not expressly approved by the manufacturer could void the user's
authority to operate this equipment.
If the size of the end product is smaller than 8x10cm, then additional FCC part 15.19 statement is required to be
available in the users manual: This device complies with Part 15 of FCC rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference and
(2) this device must accept any interference received, including interference that may cause undesired operation.