User's Guide

TRUE WIRELESS
EARBUDS
H100
User Guide
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
Any Changes or modifications not expressly approved by
the party responsible for compliance could void the user's
authority to operate the equipment.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between theequipment and
receiver.
-Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician
for help.
FCC Caution
The device has been evaluated to meet general RF
exposure requirement. The device can be used in portable
exposure condition without restriction.
RF warning for Portable device
LED Indicator Guide
Game and music modes
Music is the default mode.
Quickly press the MFB three times on the right earphone, to switch between
game and music modes, corresponding voice prompt “game mode” or
“music mode” will be heard.
Reset
Put the earphones back to the charging case, then long press the reset
button for around 3 seconds, The LED indicators flash three times.
Earphones reset successfully, the earphones will turn on automatically.
Left and right earphones will be connected automatically. Wait for a few
seconds, The white light of the earphone flashes quickly, you can take
out the earphone and reconnect with the device.
“Power On”
“Power Off”
“Pairing”
Status Description Voice Prompt
Power On
White LED indicator stays
on about 1 second
White LED indicator stays
on about 1 second
White LED indicator flashes
continuously
Power Off
Pairing
Charging –
Earphones
White LED indicator stays on
Charging –
Charging Case
the charging case indicator
light is always on while
charging. When battery
LED indicator is off, it is
fully charged.
Charging Case
Battery Low
Battery LED Indicator flashes
three times when battery case
is activated.