User's Manual

Blinking: sending/receiving data from wireless LAN

Off: Transmitter is off

LAN Green On: Good Link

Blink ing: sending/receiving data from LAN Port

Off: No link

WPS Green On:WPS Start’

Off:WPS Close

Security Green On:Security Start

Off:Security Close

Attaching an External Antenna

This AP comes with an antenna. It is external removable monopole signal-band 2.4 GHz antenna. It can be

rotated over 90 degrees and is omni-directional with a gain of less than 2 dBi. You can change a 5dBi

high gain antenna for creates a superior far-reaching wireless network

Charpter 3 CONFIGURING THE WIRELESS AP

If the default AP configuration does not meet your network requirements, or if you want to customize

the settings for your own network, you can directly connect to the device through it’s Ethernet port or

wireless to change the configuration. There are two typical applications:

1. Networks with a DHCP Server

If your network has a DHCP server, an IP address is automatic ally assigned to the AP. It takes between

one and two minutes for the Access Point to determine if there is a DHCP server on the network. After

you determine the AP’s IP address, you can enter that IP address into a web browser on a computer on

the same subnet to view the Access Point’s system status or change its configuration

2. Networks without a DHCP Server

If your network does not have a DHCP server, the Access Point uses a factory assigned IP address

(10.10.10.254). You can use that IP address to configure the Access Point, or you can assign a new IP

address to the Access Point.

To verify that the Access Point is using the default IP address assigned at the factory: Connect a

computer directly to the Access Point using the supplied standard Category 5 UTP Ethernet cable. Enter

the Access Point’s default IP address (10.10.10.254) into the computer’s web browser. If the

Configuration Management System starts, the Access Point is using the factory assigned IP address. You

can configure the Access Point with the Web interface:

Username, type admin (case sensitive)

Password, type admin

Click ok.