Specifications

Integration instructions for host product manufacturers according to KDB 996369 D03 OEM
Manual v01
2.2 List of applicable FCC rules
FCC Part 15 Subpart C 15.247 & 15.207 & 15.209
2.3 Specific operational use conditions
The module is a module with WIFI 2.4G function and WiFi 5G function
and BT function
Operation Frequency:
BT/BLE: 2402-2480MHz
2.4GWiFi：2412~2462MHz
5GWiFi：
U-NII-1: 5150 MHz to 5250 MHz,
U-NII-3: 5725 MHz to 5850 MHz
Type: PCB Antenna
Gain: 2.5dBi Max.
The module can be used for mobile or applications with a maximum 2.5dBi antenna. The host
manufacturer installing this module into their product must ensure that the final composit product
complies with the FCC requirements by a technical assessment or evaluation to the FCC rules,
including the transmitter operaition. The host manufacturer has to be aware not to provide information
to the end user regarding how to install or remove this RF module in the user's manual of the end
product which integrates this module. The end user manual shall include all required regulatory
information/warning as show in this manual.
2.4 Limited module procedures
Not applicable. The module is a Single module and complies with the requirement of FCC Part 15.212.
2.5 Trace antenna designs
Not applicable. The module has its own antenna, and doesn’t need a host’s printed board
microstrip trace antenna etc.
2.6 RF exposure considerations
The module must be installed in the host equipment such that at least 20cm is maintained between the
antenna and users’ body; and if RF exposure statement or module layout is changed, then the host
product manufacturer required to take responsibility of the module through a change in FCC ID or new
application. The FCC ID of the module cannot be used on the final product. In these circumstances,
the host manufacturer will be responsible for re-evaluating the end product (including the transmitter)
and obtaining a separate FCC authorization
2.7 Antennas
Antenna Specification are as follows:
Type: PCB Antenna
Gain: 2.5 dBi
This device is intended only for host manufacturers under the following conditions:
The transmitter module may not be co-located with any other transmitter or antenna;
The module shall be only used with the internal antenna(s) that has been originally tested and certified
with this module. The antenna must be either permanently attached or employ a ‘unique’ antenna
coupler.
As long as the conditions above are met, further transmitter test will not be required. However, the
host manufacturer is still responsible for testing their end-product for any additional compliance
requirements required with this module installed (for example, digital device emissions, PC peripheral
requirements, etc.).
2.8 Label and compliance information
Host product manufacturers need to provide a physical or e-label stating “Contains FCC ID:
2AWOC-GOC-BA440”with their finished product.