4-2. Installation of Receiver 4-2-1. Basic installation of Receiver 1. Connect the receiver to the adapter and then slide the power switch to ON position. Note: @ This receiver can also work on dry battery. Please load 4 AA batteries to the battery compartment at the back of receiver with their polarities matched. (@ The AC adapter will work instead of batteries after it is plugged. If the receiver is left unused for a long period of time, please unplug the adapter and remove the batteries.
3. Set the channel of receiver to be the same as camera by pressing the channel button continuously, and the pictures will display on the screen. Note: = For more clear pictures, please connect the receiver to a monitor/TV ‘with AV cable (yellow for video and red for audio). AV cable 4-2-2. Operation of Receiver 1. Volume adjustment Slide “Volume Switch” to adjust the volume of the receiver. 2. Channel selection Press “CH button” to select the appropriate channel. 8.
CAUTIONS ® The apparatus shall not be exposed to dripping or splashing and that no objects filled with liquids, such as vases, shall be placed on the apparatus. Turn off the Camera/Receiver if the system is not in use. The adapter is used as the disconnect device from the mains. The adapter shall remain readily operable. © The Camera/Receiver can only be completely disconnected from the ‘mains by unplug the adapter Do not cut the DC power cable of the apparatus to fit with another power source.