User Instructions

FAQ
19
20
Technical Parameters
H.265
DC 5V
Up to 128GB
214x26x157 (mm)
USB 2.0
1024 x 600
Display
Display resolution
SD card capacity
Storage video resolution
Storage format
Data output
Operating Voltage
Dimensions (length X width X height)
"
7 TFT LCD
15~85%RH
0℃~40℃
Operating temperature
Operating humidity
400m (4T1R)
Unobstructed transmission distance
All parameters are subject to minor changes without prior notice.
1920 x 1080P
1/2.9",CMOS
15~85%RH
-10℃~50℃
DC 12V/1A
20m (Max.)
Parameters
°
H：85
Items
Image sensor
Video pixels
Horizontal viewing angle
Operating voltage
IP rating
Night vision distance
Dimensions (length X width X height)
Operating temperature
Operating humidity
IP55
176x47x46(mm) (without bracket)
Interface
DC JACK（○5.5mm） RJ45
1920 x 1080P
Interfaces
USB 2.0, DC JACK（○3.5mm） MicroUSB, SD card
1. Q: Why can't the monitoring images be displayed on the screen after the camera is
connected?
A: 1. Please check if the antennas of camera and receiver are installed or configured in
place.
2. Please check if screen display of the receiver is turned on.
3. Please check if pairing is successful.
2. Q: The recording time has been set or the motion detection recording enabled. When
the time arrives or a motion is detected, why is video recording not started?
A: 1. Please check if a storage card has been inserted.
2. Please check if the storage medium works.
3. Hot swapping of storage medium is not supported. So, check if the problem is
caused by hot swapping; if it is, please power off the receiver and then power it
on again.
4. Please check if the storage medium is full. If it is full, the automatic override
function should be enabled. Check if the function is enabled ( in recording setting).
3. Q: When an external HDD is connected via the USB port, why cannot it be recognized?
A: Currently, the device does not support connection of a mobile HDD for storage.
4. Q: When an ID number is entered in the APP to add receiver, adding fails?
A: Please check the format of the ID number you have entered. A correct ID number is
the last 10 digits of the UID number.
5. Q: The alarm volume from the motion detection receiver is too large, how to adjust?
A: In the real-time preview interface, click the “Up” and “Down” arrow buttons to
adjust the alarm volume.
Cameras
Monitor
RF Characteristics