User Instructions

21
22
Troubleshooting
Check if the storage medium has been inserted; hot swapping of
storage medium is not supported. So, check if the problem is
caused by hot swapping.
Check if the storage medium is full and if the automatic override
function is enabled.
LCD does not
display monitoring
images
No videos
Poor image
quality
Problems
Solutions
Please check if the cameras are turned on.
Check if the cameras have been "paired".
Check if there is interference, such as WIFI interference or
interference from other wireless devices.
Check if the antennas of the cameras and the monitor are
installed.
SD card connection failed; it is recommended to use brand SD
card, such as Kingston, SanDisk, Panasonic, Kingmax, etc.
An external mobile HDD is not supported. Please check if it is an
external HDD that results in no videos.
Note: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions:
(1)this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
RF exposure warning :
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolledenvironment. This equipment shall be installed and operated with
minimum distance 20cmbetween the radiator & body.
This device is acting as slave and operating in the 2.4 GHz (2412 ~2462 MHz)band.
Ad Hoc function is supported but not able to operate on non-US frequencies.
Do not use the device with the environment which below minimum -30 ℃ or
maximumover 50℃ .
Hereby, we declares that this device is in compliance with the essential require
ments and other relevant provisions of Directive 2014/53/EU.
Notice: Observe the national local regulations in the location where the device is
to be used.
This device may be restricted for use in some or all member states of the
European Union (EU).
FCC Certification lnfo
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with
your local authority or retailer for recycling
advice.
EU Environmental Protection