User Instructions

ManualsBrandsShenzhen Gospell Smarthome Electronic ManualsElectronicsFour-Channel Wireless Digital Surverillance System

Table Of Contents

OK : Select MENU : Back

System Setup

Info

Channel

Source

Allow Downgrade

IPC Upgrade Settings (For Camera)

1. Press OK to enter the IPC upgrade settings interface.

2. Press the “ ” or “ ” button to select the channel to be upgraded. It is

recommended to enable “Allow Downgrade”.

3. Press the “ ” or “ ” button to select “Start” and press OK to confirm.

Note: The upgrade program needs to be

downloaded to the storage device and

upgraded via USB interface or SD card.

Online upgrade is not supported.

Local Upgrade

Start

Wired Network Settings

Add by Pairing Settings

Network cable

Receiver

Camera

1. Press MENU on the device to enter the menu interface;

2. Press OK to enter the wired network settings interface.

3. Select “Obtain an IP address automatically” and press OK to turn it on. Then, the

device will automatically obtain a network IP address; or the IP address can be entered

manually.

1. After the receiver and camera are powered on, the camera is connected to the

receiver by a network cable;

2. Press MENU on the device to enter the menu interface;

3. Press OK to enter the Match Code Settings interface;

4. After connecting the camera to the receiver by a network cable, press

the “ ” or “ ” button to select “Match Code” and press OK to confirm;

5. Press the “ ” or “ ” button to select the “x” on the right side, and press OK

to delete the paired camera.

6. After a paired camera has been deleted,

if you want to re-pair, just turn on the

camera and keep it within an effective

range of wireless connection, and then

you can complete pairing with no need

of a network cable (if you want to avoid

pairing again, please turn off the camera);

OK : Select MENU : Back

System Setup

0xe01f0008

0xe01f0007

0xe01f0006

0xe01f0005

Camera-1

Camera-2

Camera-3

Camera-4

Matched

Match Code

Wireless Hotspot Settings

1. Press MENU on the device to enter the menu interface, and press OK to enter the

wireless hotspot settings interface;

2. Press the “ ” or “ ” button to select the appropriate “Area and Wireless

Channel”, press OK to confirm and exit.

Note: This feature is only used for wireless connections between the “Receiver and Camera”.

System Information Settings

Upgrade Settings(For Monitor)

Factory Settings

Volume Output Settings

1. Press MENU on the device to enter the menu interface, and press OK to enter the

system information settings interface;

2. Press MENU to exit.

1. Press MENU on the device to enter the menu interface, and press OK to enter the

upgrade settings interface. Select “Local Upgrade” and press MENU to exit.

Note: The upgrade program needs to be downloaded to the storage device and

upgraded via USB interface or SD card. Online upgrade is not supported.

Press MENU on the device to enter the menu interface, and press OK to enter the

factory settings interface.

1. Simple restore: ignore channel and network configuration

2. Restore all: restore all configurations

1. Press MENU on the device to enter the menu interface, and press OK to enter the

wireless hotspot settings interface;

2. Press the “ ” or “ ” button to select an appropriate volume (0-4), and press OK

to confirm and exit (in the real-time monitoring state, press the “ ” or “ ” button

to adjust the volume).

Note: The defaulted volume is (2)