User's Manual

Table Of Contents

Operations

● Basic operations

1. Connect the camera to the power supply. The power Indicator

on the back is turned on:

3. Press the power switch on the receiver for 2s. or press

the power switch on the remote control(direct the remote

control toward the receiver).

The power indicator is turned on and the power-on picture

appears.

4. Pair the cameras and receiver respectively (at most four cameras

can be connected at the same time). Pairing is completed by

default before delivery. If pairing is not completed, complete

pairing according to “Pairing” on page 16.

2. Connect the receiver to the power supply.

6. Press the button to switch between four display modes:

2011/11/05/09:30

图像显示区域

Four pictures One picture

One large picture and

three small pictures

One large picture and

three small picture

7. Press the button to enter cyclic mode display. Five cyclic

intervals are available: 5s, 10s, 15s, 20s, and 30s and can

be set under “System”.

Meanings of icons on the real-time monitoring picture:

Mobile hard disk inserted

successfully

SD card inserted successfully

Camera name

Signal intensity

Recording status

Current camera

2011/11/05/09:30

2011/11/05/09:30 2011/11/05/09:30

5. After successful pairing, the following real-time monitoring

picture appears:

2011/11/05/09:30

Picture display area

Time stamp

Picture display area

Picture display area Picture display area

Picture display areaPicture display area

Picture display area