Users Manual

Instructions
Ɣ7XUQRQWKHKHDGVHW
In the power-off state, press and hold the multi-function button for 3
seconds until you see the blue light on, accompanied by a "Di Di"
sound, and automatically enter the pairing mode. The red/blue
flashes alternately, and the paired device will be automatically
connected.
Ɣ7XUQRIIWKHKHDGVHW
In the power-on state, press and hold the multi-function button for 4
seconds until the red light is on, accompanied
by a beeping sound.
Ɣ'LVFRQQHFWDQG5HFRQQHFW
When the headset and the device exceed the Bluetooth connection
distance, the headset will be disconnected, and there will be a "Di Di"
sound. It will automatically reconnect when it returns to the headset
and device connection range within 3 minutes. If it exceeds 3
minutes, it will enter the standby state , if it is still not connected after
5 minutes, the headset will automatically shut down.
Ɣ6ZLWFKEHWZHHQ%OXHWRRWKPRGHDQGORFDOVWRUDJHPRGH
In the power-on state, double-click the multi-function button, the
Bluetooth mode and the local storage mode are switched alternately,
and the prompt sound of "Bluetooth mode" or "Card mode" will be
heard.
Ɣ1LJKWUXQQLQJOLJKWPRGHRQRURII
In the power-on state, three-click the multi-function button, the night
running light mode will be switched between three modes: always on,
flashing, and off.
Ɣ7RDQVZHUUHMHFWFDOOV
When there is an incoming call, short press the multi-function button
to answer, accompanied by a "Di Di" or the phone's own prompt; long
SUHVVWKHPXOWLIXQFWLRQEXWWRQWRUHMHFWWKHFDOO
Ɣ+DQJXSWKHFDOO
During a call, click the multi-function button to hang up;