User's Manual

2 Main User interface
2.1 Power up
Plug the power supply into the base. The in use LED will power on and TONE_CONFIRM.
Insert batteries in the handset. If battery level is enough (see Start up with low batteries chapter), the
handset will start.
The display will show “BASE 1” and antenna flashing, until it locks onto its subscribed base. If the
handset finds its base in the first 10 seconds, no beeps are played (see Range indication chapter).
Then the display shows the standby display.
2.2 Standby mode
In standby mode, the display shows the current time and the handset number, preceded by HS.
The ANTENNA icon is steady. The BATTERY icon indicates the charge level.
Handset:
Events Handset mode
Press KEY_HOOK Enter TALK mode
Press KEY_INT Enter intercom mode
Press KEY_MENU Enter MENU mode
Press KEY_MEM Enter phonebook mode
Press KEY_STAR/LOCK
(hold 3 second)
Enter KEY LOCK mode
Press KEY_LNR/PAUSE Enter redial list mode
Press KEY_DOWN/CLIP Enter CLIP mode
Press KEY_R/POWER
(hold 3 second)
Enter power down mode
Press 1,2,3……0,*,# Pre-dialling
Incoming call signal Incoming call mode
Another handset TALK Busy mode
Battery is low Battery low icon
Battery is too low Power down mode
On charging Charging mode
Long press for 1 or 2 Access direct pre-programmed
number
Base:
Events Base mode
Press PAGE KEY Enter PAGE mode
Long press PAGE KEY Enter SUBSCRIPTION mode
Incoming call signal Incoming call mode
2.3 TALK mode
Refer to External outgoing call
20 of 83