User's Manual

The time is adjustable by FP EEPROM settings
3.2.4 Flash key
During a call, press shortly KEY_R to perform a Flash break and displayed as a “R”.
The flash time is adjustable by FP EEPROM settings
3.2.5 DTMF dialling
DTMF tone duration (pause before, tone length, pause after, high & low group level) is adjustable by
FP EEPROM settings
3.2.6 Pulse dialling
Pulse timing (make, break, pause after) is adjustable by FP EEPROM settings
Pulse dialling mode can be disabled by EEPROM settings.
(If disabled by setting, the dialling setting menu shall not be on the handset setting menu)
3.2.7 Temporary DTMF dialling
During a call or pre-dialling, when the selected dial mode is pulse and you want to dial DTMF codes,
During talk,
long press KEY_STAR/LOCK to switch into DTMF dialling, only during this call.
During pre-dialling or number storage, long press KEY_STAR/LOCK is used to program the digits
after the KEY_STAR going temporarily to DTMF dialling. This will be displayed as a “d”.
3.2.8 Dial tone detection
During an external outgoing call, the dial tone detection is activated. When detected the digits which
have been dialled on the handset (pre-dialled or post dialled) are sent to the line.
If the dial tone is not detected, a time out expires and the digits are sent.
The time out is adjustable by FP EEPROM settings
No dial tone detection time out : selected by EEPROM data
with dial tone detection time out : selected by EEPROM data
3.2.9 Call timer display
After going off hook, the display is blank during 15 s unless you press a key. The communication
duration is displayed after 15 s after the last pressed key. This delay duration can be set as an
EEPROM parameters.
If you press a key (0 - 9) during the conversation, the communication duration is not reset to zero and
reappears after 15 seconds. At the end of each call, the duration of communication and the handset
name are displayed alternately for 5 seconds.
3.2.10 Mute
It is possible to mute the microphone during a conversation.
Press KEY_CLEAR/KEY_MUTE during the conversation, the microphone is then deactivated, the
external correspondent is put on hold; you can talk freely without being heard by the calling party.
“MUTE” is displayed.
No digit key or KEY_INT can be used during mute.
And Phonebook can be reviewed but can’t be dialled out during mute.
From Mute function, the following key functions are active
 Press KEY_CLEAR/KEY_MUTE again to return to normal mode.
 Press TALK_OFF to finish the conversation
If call is muted before CID is received, CID will be displayed in preference to “MUTE” for 7 seconds.
24 of 83