User's Manual
Table Of Contents
- Feature List
- Features of SunCorp GAP DECT
- Main User interface
- Call User interface
- MENU Settings
- MESSAGE PLAY
- PHONEBOOK
- TAM SETTING
- SMS
- SETUP
- HANDSET
- REGISTER
- Answer machine features
- Base description
- Base unit operation
- Call answering and message recording
- Memory full
- Message playback
- Remote interrogation.
- Technical requirement
- Default setting data
- Setting for countries variance and type of product
- BPR detection (Branch Phone Detection)
- CPC (ECS) detection (End of call signal)
- Silence detection
- Tone detection
- DTMF detection
- AGC for recording
- Audio out put level setting
- Supervisory tone
- Tail cut
- Ring signal detection
- LED flashing
- Data storage
- Prefix dialling
- Quick default settings
- Subscribe a new handset
- Test modes
- Specifications
DTMF max delay The maximum delay allowed between DTMF tones
in a DTMF CID in multiples of 100ms (Inter-digit
delay)
10 (1 second)
CidDtmfIgnoreD3 If set to 1, then CID of type D3# will be ignored. 0
CidDtmfPrefixZeros If set to 1, then CID with length 8 or 9 will be
prefixed with 0 and length 10 or more will be
prefixed with 00
0
CidDtmfVmwiNumberMatch If set to 1, then each CID is compared to a pre-
defined VMWI center number
0
DTMF VMWI Match Size Number of digits in CID DTMF VMWI matching
number. Maximum value is 12.
0
DTMF VMWI Match Digits Digits 0 to 11 of CID DTMF VMWI matching
number.
0
Special caller texts display format:
Display CLIP TYPE Caller texts from network
WITHHELD Holland DTMF D0000000000C (SECRET)
3.8.3 Recall CLIP list
Unanswered and answered calls are stored in the CLIP list of each handset independently (in
EEPROM).
Note: any new CLIP call will be stored in EEPROM .
Size storage
Each entry will store:
¾ The call number (20 digits)
¾ The caller name (12 digits) if the network send it
¾ The date and hour of the call
Storage sequence
The CLIP information that has been received during incoming alert phase (calling number, name
date/hour) is stored then displayed.
I
f the new call entries, The
icon will flash (480ms ON/OFF) and will off after all new call is read.
Note: The new message indication is reset at power up, so the
icon is always off after a reset.
MMI operation
To retrieve the entries:
1. Press KEY_ UP/CLIP or KEY_ DOWN/CLIP to enter the call list. The icon will stay ON
for Unanswered Calls and the
icon will stay ON for Answered Calls. If the list is already
/CLIP and down KEY_DOWN/CLIP arrows.
3. You w
viewed. The
empty, then “EMPTY” is displayed
2. Scroll through the calls using the up KEY_UP
ill find the different fields of the entry:
If the call is unanswered and un
and icon will stay ON. The
will be turned off after it is viewed.
If a matched number found in phonebook memory , the corresponding name will be
shown otherwise if the caller name is available, the caller name will be displayed. If
both are not available, the caller number is displayed first.
29 of 83