User's Manual

Default v s will be ENABLED. alue will be that the display of the service centre menu
4.4.5.7 TERMINAL NUMBER
The user can enter the network specific default sub-address.
• Select “TERMINAL NO”
• Modify the terminal number, the values can be 0, 6..9
• Press KEY_OK to confirm
A ne E ide tw EPROM parameter will be defined to h he Terminal number menu.
In thi below. s case the SMS SETTINGS menu option will be as shown
SMS SETTINGS MSG ALERT ON
FF O
SEND SERVICE SEND 1
SEND 2
RCV CENTRE RECEIVE 1 NUMBER ?
RECEIVE 2 NUMBER ?
SEND CENTRE SEND 1 NUMBER ?
SEND 2 NUMBER ?
Def t enu will be ENABLED.
4.4.
The umber used to dial the sending service centre will be generated according to a sending mode parameter.
e sending mode will define
w its of the SEND CENTRE number will remain or be removed
ess of the terminal will be appended
whether the default DMI value of zero will be appended
The ast two digits of the SEND CENTRE number, and append both the
sub- r
o a receiving mode
te CENTRE number. The parameter will be stored in EEPROM, but will
iving mode will define whether the last two digits of the RECEIVE
CEN r be removed during the number comparison.
the last two digits of the RECEIVE CENTRE
• Select "SETUP"
aul value will be that the display of the Terminal Number m
5.8 SENDING MODE (Hidden in the EEPROM)
n
The dialed number is generated from a combination of the SEND CENTRE number, selected either from SEND
1 or SEND 2, the terminal sub-address, and the default DMI value. The parameter will be stored in EEPROM,
not be changebut will able by the user. Th
• hether the last two dig
• whether the sub-addr
•
default sending mode will be to keep the l
add ess of the terminal and the default DMI.
4.4.5.9 RECEIVING MODE (Hidden in the EEPROM)
The number used to compare the incoming SC number will be generated according t
parame r from the selected RECEIVE
not be angeable by the user. The recech
TRE number will remain o
The default receiving mode will be to use
number in the comparison.
4.5 SETUP
51 of 83