User's Manual
Table Of Contents
- Feature List
- Features of SunCorp GAP DECT
- Main User interface
- Call User interface
- MENU Settings
- MESSAGE PLAY
- PHONEBOOK
- TAM SETTING
- SMS
- SETUP
- HANDSET
- REGISTER
- Answer machine features
- Base description
- Base unit operation
- Call answering and message recording
- Memory full
- Message playback
- Remote interrogation.
- Technical requirement
- Default setting data
- Setting for countries variance and type of product
- BPR detection (Branch Phone Detection)
- CPC (ECS) detection (End of call signal)
- Silence detection
- Tone detection
- DTMF detection
- AGC for recording
- Audio out put level setting
- Supervisory tone
- Tail cut
- Ring signal detection
- LED flashing
- Data storage
- Prefix dialling
- Quick default settings
- Subscribe a new handset
- Test modes
- Specifications
4.5.7 Default settings
nction will not be available when t is out of range of the base or unregistered.
s you to reset both han se with default settings.
,
e and va
, press KE o confirm
By quick default,
“DEFAULT” appears, then
Th ter settings and make a software RESET.
Default par
This fu he handset
This menu enable dset and ba
By SET UP menu
• Select "DEFAULT"
• Enter the base PIN cod lidate
• "CONFIRM ?" appears Y_OK t
• Press and hold * key when insert the battery for 5 seconds,
“CONFIRM?”, press KEY_OK to confirm
en e handset and base will apply default parame th
ameter Value
et me TBD
ON
Hands na
Low battery indicator
Out of range indicator ON
Key click
uto answer
ON
A ON
INT melody 1
INT volume 3
EXT melody 1
EXT volume 3
ear volume 3
Language English
Phonebook Empty
CLID list Empty
Redial list Empty
PIN CODE 0000
PAUSE 3 s
dial m ode DTMF(Tone)
OFF
00 :00
Key lock
CLOCK
ALARM OFF
RECEIVE 1 tbd
RECE 2IVE tbd
tbd
tbd
VICE
SEND 1
SEND 2
SEND SER SEND 1
MSG RALE T ON
NO 0
ODE 3 (Dial SMS-C number + senders SA digit + DMI mode 0)
MODE 0
TERMINAL
SENDING M
RECEIVING
Defau alu for
each co
The fo win M parameters, see also CID
S Timing Default values.
fault par
lt v es in handset and base are defined by EEPROM settings [1]. So they can be adjusted
untry.
llo g table contains the default values to be used for new EEPRO
parameter defaults and SM
De ameter Value
RECEIVE 1 Network Type 0
RECEIVE 2 Network Type 0
SEND 1 Network Type 0
53 of 83