User's Manual

SEND 2 Network Type 0
Date 01-01
PB Match with # ENABLED
PB Match with * ENABLED
PB Match with ‘P’ ENABLED
VMWI Base LED Flash ON
“In call” Base LED Flash Rate 500ms
“Event” Base LED Flash Rate 750ms
4.5.8 RCID (MENU can be enabled or disabled by EEPROM)
This feature provides the opportunity to enable or disable Russian CID. Menu can be enabled or
disabled by EEPROM.
• Select “RCID”
• Select “ON” for enabling Russian CID mode
• Or select “OFF” for normal CID only
tically.
u is available:
… 7
• If the Russian CID mode is selected, the number 255 will be sent to the line atuoma
Furthermore, the following submen
NUM LENGTH 5
RING DELAY 0 … 9
Note:
1. If RCID is set to on, it is equal to select Russian CID auto mode. In this case, user is able to set
ID information is only shown on the display after user take the line or
ay
w this incoming number instead of “SCREEN?”. When the caller leaves a message,
“SCREENING” is displayed.
4.5.8.1
• ING DELAY setting. The ring
delay in answering machine is set to e.g. 2, so after 2 rings the answering machine will
starts, the incoming number will be displayed and start OGM.
UAL MODE)
y in answering
ndset on the
4.5.8
•
ignored.
4.5.8
Techni a
RING DELAY. Incoming CID will be shown on the display after certain rings set by user.
2. If RCID is set to off, it is equal to select Russian CID manual mode, in this case, RING DELAY will
not be significant. The incoming C
TAM seize the line.
3. When the answering machine answers the call and the incoming number is identified, the displ
should sho
RCID ON (AUTO MODE)
If to set auto mode in RUS CID, so Ring delay will follow R
switch on, RCID procedure
4.5.8.2 RCID OFF (MAN
• If to set manual mode in RUS CID, so Ring delay will be 0. The ring delay in answering
machine is set to e.g. 4, so if after 2 rings the recipient will pick up the handset, RCID
procedure starts, the incoming number will be displayed but answering machine won’t
switch on.
• If to set manual mode in RUS CID, so Ring delay will be 0. The ring dela
ick up the hamachine is set to e.g. 4, so if after 2 rings the recipient will p
parallel connected terminal equipment, RCID procedure starts, the incoming number will
be displayed but answering machine won’t switch on.
.3 NUM LENGTH
Select number length between 5 … 7, the max number length of CID received will be
limited to the selected value.
• Number with length longer than the set value will be
.4 RING DELAY
• Select ring delay between 0 … 9, the answering machine will switch on after the
corresponding number of rings if RCID is set to ON.
l requirement for the RUc S CID:
54 of 83