User's Manual

1. For the nt, which forms and transfers in the communication line a frequency signal
«Search» ing subscriber, the following
quirements should be carried out:
1.1. Frequency of a signal «Search» should be (500±2,5) Hz.
al «Search» in points of connection to the communication line should not
1.3. T wave form.
signal «Search» to the communication line should occur in one of the following
l a microtelephone tube by the subscriber;
- At the answer of the caused subscriber to parallel connected terminal equipment.
Technic achine:
2. If nswer to an entering call in this mode the
be carried out:
the communication line at receipt no more than six
par s
2.2. te train the terminal equipment should transfer the causing
message. If during transfer of the proceeding message or during recording
terminal equipment is going to a colloquial mode, the answering machine
sho
2.3. e nication line on the part of terminal equipment should
occur at receipt of a signal «Is busy» or upon termination of time of recording of the entering message
established by the manufacturer.
2.4. In a mode without recording the entering message the release and clearing of a line on the part of
hould occur upon termination of reproduction of the proceeding speech
4.5.
•
• When “ON” is selected, ECO Mode in Base will be activated.
1. E
communication
le, if handset talking with external line, handset will monitor the Received
) of the traffic channel. If the RSS value is larger than RSSI threshold which
ndset MCU will control RF
transceiver d
z Hands w rst time.
z Handset cannot toggle ECO mode in idle and standby mode.
z Handset will try to enter ECO mode when handset is talking with base, entering Base setting,
enter SMS menu.
n one
e based on their RSSI
receiv
z Hands E AX value in EEPROM.
2. ECO Mode in Base through operating the menu in Handset
e Low Power menu in Base Setting to let user enable or disable Base ECO mode
ot enter ECO mode automatically like handset.
base by factory default, base will enter Low Power mode when
z If ECO o e
norma n
z If ECO o
z If there is ccessed by any
terminal equipme
with the purpose of automatic definition of number of the caus
re
1.2. The level of a sign
exceed 0 dBm.
he signal «Search» should have the sine
1.4. Transfer of a
modes:
- At remova
- At imitation answer of the caused subscriber by an answering machine, the modem or the fax -
modem;
al requirement for the answering m
the terminal equipment provides the automatic a
following requirements should
2.1. The terminal equipment should close a train of
cel of a calling signal.
Af r short circuit of communication line
subscriber the proceeding
the entering message the
uld be disconnected.
Th release and clearing of the commu
the terminal equipment s
message.
9 ECO MODE
Select “ON” or “OFF” and validate
Technical requirement of ECO mode:
CO Mode in Handset
Handset will be automatically in ECO mode according to the RSSI value during
with base. For examp
Signal Strength (RSS
set in EEPROM, handset will enter ECO mode automatically, ha
to ecrease the transmit power.
et ill check ECO mode when find the registered base in fi
access TAM and
z Handset ECO mode will not be affected by base, that means if there is more tha
hands re rs to ECO modet gister to base, different handsets ente
ed.
t CO feature can be disabled if RSSI threshold is set to Me
There is on
manually. Base cann
z If ECO mode is enabled in
power up.
m de is enabled in base, there is ECO icon in handset LCD dashboard to replac
tenna icon. l a
m de is disabled in base, base will be in normal TX power mode.
any one Handset is talking with base, Base ECO mode cannot be a
55 of 83