User's Manual
Table Of Contents
- Feature List
- Features of SunCorp GAP DECT
- Main User interface
- Call User interface
- MENU Settings
- MESSAGE PLAY
- PHONEBOOK
- TAM SETTING
- SMS
- SETUP
- HANDSET
- REGISTER
- Answer machine features
- Base description
- Base unit operation
- Call answering and message recording
- Memory full
- Message playback
- Remote interrogation.
- Technical requirement
- Default setting data
- Setting for countries variance and type of product
- BPR detection (Branch Phone Detection)
- CPC (ECS) detection (End of call signal)
- Silence detection
- Tone detection
- DTMF detection
- AGC for recording
- Audio out put level setting
- Supervisory tone
- Tail cut
- Ring signal detection
- LED flashing
- Data storage
- Prefix dialling
- Quick default settings
- Subscribe a new handset
- Test modes
- Specifications
• The current date will be displayed as 01-01
• Enter the new date and validate. Note that during date entry, the user will be prevented from
-31 are valid and
for MM, the values 01-12 are valid. Date validation will be performed for each month. An error
beep sho ld be given to the user on each invalid number entry and the user will be required to
alid number. The user can cancel out of date entry at any point, by the use of the
<KEY_CLEAR>
appear. When
• Note also that this function will not be available when the handset is out of range or
KEYS
• Enter the number to be stored and validate
• The Hot Key will be automatically enabled after storing the number.
4.6.13 KEY LOCK
This function allows you to lock the key
• Select "KEY LOCK?” and validate
• Press KEY_MENU/OK to lock key,
entering an invalid date in each of the DD or MM parts. For DD, the values 01
u
re-enter a v
• Note that when in using a HS with previous Base version, this menu will not
using a previous HS with the new Base version, the old handset will not use the new date
setting, even though it is supported by the base.
unregistered.
4.6.12 HOT
This function allows you to edit the 2 Hot Key number.
• Select Hot Key 1 … 2 and validate
icon displayed and go to standby mode.
Note :Press KEY_HOOK key can be OFF HOOK during incoming call and KEY LOCK is on.
4.6.13.1 Quick KEY LOCK
Simply press and hold KEY_STAR/LOCK 3 second
4.6.13.2 To unlock key:
• Press any key “PRESS *” is displayed, within 5s time out
• Press KEY_STAR/LOCK to unlock key
4.7 REGISTER
• Select "REGISTER" and validate
• Select “SELECT BASE” or “REG BASE” by KEY_UP or KEY_DOWN
• Press KEY_OK to confirm
4.7.1 SELECT BASE
• Select "SELECT BASE" and validate
• “BASE 1 2 3 4” is displayed ( only the registered base number will be shown and current
base number will be blinking)
• Press 1 - 4 to confirm the selection or KEY_UP/KEY_DOWN + KEY_F to select auto
searching.
• Valid tone is sounded if valid base is found
• “NOT REGISTER” is shown and error tone sounded the selection is invalid
4.7.2 REG BASE
• Select "REG BASE" and validate
• “BASE 1 2 3 4” is displayed ( only the registered base number will be blinking )
• Press 1 - 4 to confirm the selection
• It is now searching the base in subscription mode and “SEARCHING…” is displayed
58 of 83