User's Manual
Table Of Contents
- Feature List
- Features of SunCorp GAP DECT
- Main User interface
- Call User interface
- MENU Settings
- MESSAGE PLAY
- PHONEBOOK
- TAM SETTING
- SMS
- SETUP
- HANDSET
- REGISTER
- Answer machine features
- Base description
- Base unit operation
- Call answering and message recording
- Memory full
- Message playback
- Remote interrogation.
- Technical requirement
- Default setting data
- Setting for countries variance and type of product
- BPR detection (Branch Phone Detection)
- CPC (ECS) detection (End of call signal)
- Silence detection
- Tone detection
- DTMF detection
- AGC for recording
- Audio out put level setting
- Supervisory tone
- Tail cut
- Ring signal detection
- LED flashing
- Data storage
- Prefix dialling
- Quick default settings
- Subscribe a new handset
- Test modes
- Specifications
• Valid tone is sounded and “PIN ?” is shown if valid base found
• d verified by base
• Valid tone sounded if subscription is successful and back to standby mode.
On the base:
g PAGE_KEY
• The base will then emit a beep, the Line LED will flash. It is now ready to be associated with a
new hand during the 90 seconds after pressing the button only.
s located the base, a valid tone is played.
ate the base, it will return to the previous configuration after 1 minute. Try
aga b e number and check that you are not in a environment where there is
interference
a a base, it is given a handset number by the base. It is this number
whi andset after the name and must be used for internal calls.
Enter subscription PIN code an
• Put the base into subscription mode, by pressing and holdin
set,
If the handset ha
If th ae h ndset does not loc
y changing the basin
When handset is associated with
ch is displayed on the h
59 of 83