User's Manual

2.5.5.） Camera
select the camera setting, there will be a loop, delete and add ,three
sub options, use the up and down key to select , when you press
the ok key to select the loop settings item, and the three sub
options will pop-up as follows
Select by up and down key, and press the ok key to confirm
(check the camera 1 means the camera 1 is locked in the monitor
screen. select camera 2 means the camera 2 is locked in the monitor
screen. Select the loop item to means the camera 1 and the camera
2 are in the monitoring screen by Cycle switching)When you select
the delete item, press the ok key to pop up the two sub-options as
shown in the following figure