Use Manual

1.使用 产品 前请 把耳 机放 入充 电舱 ，充 电半 小时 后再 使用.
.打开 充电 舱 耳机 自动 开机2 拿起 ,耳机 配对,进 入搜 索模 式.
.打开 手机 蓝牙 设备,点 击 链接 即可.3 H01
4.当耳 机与 手机 断开 链接 ，耳 机5分钟 后自 动关 机！
Thank you for purchasing and using this product
please read this instruction of use carefully as to
bring you better experiense of use.
Product Specification:
H01
Charging case capacity
Product Overview:
Input
Charging pin
Output
L-Battery
Battery of charging case
MIC/light hole
Touch pad
R-Battery
三击 右耳 音量 加
三击 左耳 音量 减
产品概况
1.给耳机充电时,红色指示灯常亮,充电完成后指示红灯熄灭,蓝灯长亮
10秒后熄灭;(注:红灯没有亮起,说明耳充电头没有接触好,请重新摆放)
2.给电池盒充电时,电池盒显示屏数字慢闪,充满后电池盒显示屏长亮,
移除充电线显示屏关闭;
1.耳机 电量 不足 时， 红色 指示 灯闪 烁并 有语 音提 示；
2.耳机
电
量
耗
尽
后
会 自
动
关机 。
充电使用说明
低电量提醒说明
配件清单
注意事项
1.切勿 使用 具有 腐蚀 的清 洁剂 清洁 本产 品.
2.如果 长时 间不 使用 本产 品， 请将 耳机 放入 电池 盒内 储存 ，并 确
保储 存环 境干 燥,并每 月至 少给 电池 盒充 电一 次.
3.使用 本产 品请 将系 统音 量调 整至 适中,长 时间 音量 过大 有导 致听
力受 损的 风险.
4.禁止 拆解,撞 击,抗压 或投 入火 中,若出 现鼓 胀,请忽 继续 使用,请 忽
置于 高温 环境 中.
按键功能说明
使用说明
Instruction of use
Call answer
Short press
Call reject
Long press
Call end
Short press
Voice assitance
Long press 1.5 second
1.Please put the earbuds into the charging case and charge 30
minutes before start when receive our product
Touch Function instruction
2. The earbuds are turning on and pairing automatically after
open the charging box and pick them up
3 click on right earbud to volume+
3 click on the left earbud to volume-
温馨提示
由于 耳机 是触 摸式 操作 模式 ，在 取出 耳机 的过 程中
手指 尽量 不要 碰到 耳机 中间 触摸 点。 如果 不小 心手 指按 在触 摸点
上引 起耳 机自 动关 机时 候， 请把 耳机 放回 充电 仓重 新取 出使 用。
耳机 在不 放入 充电 仓的 情况 下需 要关 机的 话请 长按 触摸 点， 闪几
下红 灯后 耳机 关机 ，需 要开 机的 话长 按触 摸点 闪蓝 灯即 是开 机状 态。
耳机功 能：
1 4
2
3
5
6
功能
按键
音频
LED
耳机充 电模式
n/a
红灯长 亮
耳机充 满
电模式
n/a
转蓝灯 后
10秒熄 灭
断开蓝 牙待
机模式
n/a
连接 中断
Di sc on ne ct ed
左声道 进入
红蓝灯 交替
闪搜索 状态
配对状 态
待机模 式
n/a
低于3V3.电量
不足，请充电
（low Bettery)
隔3秒，红灯
快闪1次
（250MS）
低电量 模式
n/a
红蓝灯交替闪
进入配对模式
从充电仓拿
起自动配对
进入配对模式
（Paring mode）
红蓝灯交替闪
耳机之间配
对成功
n/a 已连接
（di Paring mode）
右耳灯灭
左耳进入红
蓝灯交替闪
来电
n/a n/a
蓝灯间隔3秒
快闪5次
连接手机蓝牙
n/a
con nec tio n
suc ces sfu l
主耳蓝灯慢闪
右耳进入红蓝
灯闪替闪
n/a
n/a
n/a
n/a
n/a
n/a
n/a n/a
n/a
长按1
.
5秒
短按
1.连接无线播放音乐没声音
手机断开无线耳机之后再连接
耳机放进充电仓后再拿出来连接手机无线
对手机音量键进行调节音量
2.无法TWS配对
非法操作会导致耳机无法进入TWS配对
耳机关机再开机进行操作
耳机手动开机，长触摸耳机到红蓝灯交替闪松手，三击
耳机触摸按键，红灯闪三次即自动关机，此操作为清除记
忆操作（注意：两个耳机都要进行此操作）。再次打开耳
机连接即可。
3.通话质量差
离开wifi密集地方再通话，因为无线和wifi同时在2.4GHz频段
上工作会有互相干扰。
通话时，没戴耳机方把手机通话音量开大。
通话时，戴耳机方把耳机跟手机的距离调短点。
耳机电量太低会影响通话质量。
45mAh*2
4. The earbuds would be powered o automatically in 5 minutes
after disconnection from the mobile devices
3.Search“H01”and connect after turn on
the bluetooth function in your devices
MIC孔/灯孔
Warm reminder
As the earbud is a touch mode of operation, fingers should not
touch the touch point in the middle of the earbuds when removing
the earbuds. please put the earbuds back into the charging case
and take it out again if shut down automatically caused by the
wrong press on the touch point, please press the touch point for
a long time to power off the earbuds without
Putting them into the charging case , it is done after red light flash
several times. If want to power on them again , just press the touch
point for a long time until the blue light flash
Earbudsfunctions
Functions Key Audio
Led
Earbuds
charging mode
Earbuds full
charge mode
Standby mode
of Bluetooth
disconnect
Standby mode
of pairing status
Low battery
mode
Enter pairing
mode
Successful
pairing
Income call
Paring
automatically
after pick up
from charging
case
Disconnect
Low Battery,
please charge
Enter pairing
mode
Connnected
Connnected
Red light
long on
Go out in 10
second after
turning blue light
The left earbud
enters the searching
mode of red and blue
light flashing alternately
Red and blue
light flashing
alternately
1 4
2
3
2,The digits in the display screen flash slowly when the charging
bix is charging, the display screen is always on when the charging
box is fully charged, the light is turned off when the charging
cable is removed.
Charging instruction
1.The red light is always on when charging the earphones, and if full
charge,the red light is off, and then blue light light up for 10 seconds
until off （Noted: the charging pins should be not in good contact if
the red light is not on , please pick up the earphones and put them
them back again)
Low battery reminder
1,The red light indicator is flashing with voice prompt when the
earphones are in low battery condition.
5
Accessories
Earbuds
large size
USB cable
Manual of Use
Manu al of Use
Warning
1.Do not use corrosive detrgent to clean this product.
2.If you do not intend to use this product for a long period of time ,
Please put the headsets back into the portable charging case,store it
in a dry environment and charge the headsets at least once a month
to prolong its life.
3.Please turn to the modest volume to avoid noise and damage
hearing.
4.Do not disassemble,trike,squeeze or put into fire.Once it is bulging,
do not continue to use.Do not put it in high temperature environment.
Small size
6
Connect wireless
to mobile devices
Red light quick
flash once every
3 second
Red and blue light
f
la
s
h
i
n
g a lternately
The right earbud
enters the searching
mode of red and blue
light flashing alternately
Blue light flashing
5 times every
3 second
Blue light of master
earbud slow flash
and then enter the
status of red and
blue light flashing
alternately
中文
英文
Common problems and Solutions
2,The earphones are turned off automatically when the earphones
run out of battery.
1.Play music but no sound after connect to wireless
A, Re-connect to mobile phone after disconnection.
B, Put them back to the charging case and pick up to re-connect.
C,Adjust the phone volume by the volume key.
2.Unable to pair TWS
Illegal operation will cause headphones to fail to access TWS pairings
The solution is to Turn off the headset and turn on again
Here is the instruction of operation: Turn off the earbuds manually
A long press on the touch point until the red and blue lights flashing
alternately, and then 3 short click on the touch point of earbuds, it
would power off automatically when red light flash 3 times . this is
called memory-clearing operation. (note: this operation need to be
made on both of the earbuds), finally , we just need to power on the
earbuds again for re-connnect.
3.Poor quality of calls
Leave the WIFI intensive area and call again, because it might cause
the interfere when wireless and wifi work on the same frequency band
of 2.4Ghz at the same time
When talking, the side without headset need to turn the voice louder
When talking, the side with headsets need to shorten the distance
between headsets and mobile phones.
low Headphone battery will cause poor quality of calls.
H01
ABS+ PC
10M
5.0
98g
2000mAh
45mAh* 2
（2400- 2483.5）MHz
由于 本产 品是 触摸 式操 作。 当耳 机掉 入水 中时 候， 由于 水接 触到 触
碰按 键， 耳机 会自 动关 机。 在水 里一 段时 间后 ，水 珠会 进入 喇叭 孔
部位 ，建 议甩 一下 水珠 并且 放入 充电 仓过 几小 时， 等水 分
充分 挥发 耳机 才会 恢复 正常.
防水说明
Waterproof instruction
As this product is a touch mode of operation，the headsets are
off automatically in the water as a press on the touch point by
water .the water will go inside through the speaker holes after
a while ,a suggestion of throw away the water first and then put
into the charging case for charging for few hours, the moisture
will take time to volatile and then the headsets work as
normal again
常见问题及解决方法
English