Safety Instructions

，

INITIAL SETUP

ESSENTIAL SETUP

1. Place the unit on a ﬂat and level surface.

The selected location should be stable and free

from vibration.

2. Insert the hinges into the slots on the transparent lid.

Then insert them into the hinge holders on the back

of the main unit.

3. Remove the tie-wrap that is holding the tonearm.

4. Place the slip mat on top of the turntable platter.

5. Connect the speakers to the speaker jacks at the

back of the unit.

6. Connect power adapter to the power jack of the unit.

Note: Do not plug the power adapter to power outlet before all the assembly is completed. Before

turning the power on, make sure again all the connection settings are correct. Always turn off the

power when connecting or disconnecting.

TURNTABLE PLATTER AND BELT SETUP

1.Insert the latter into the turntable spindle located in the middle of

the turntable, then rotate the platter until you see the drive motor

pulley through the window at the top right corner.

2.Carefully grab the drive belt and put it around the slot of motor

pulley.

TONEARM COUNTERWEIGHT ADJUSTMENT FOR STYLUS PRESSURE

1. Gently push and turn the Counterweight onto the

rear of the tonearm (with the dial facing toward the

front of the turntable). Remove the stylus protector

from the cartridge and avoid touching the stylus tip during the adjustment.

2. Release the tonearm clip, gently hold the tonearm and move it away

from the Tonearm Rest and position the cartridge in the space between

the tonearm rest and platter. At this point, the tonearm is unbalance and free to swing.

3. Carefully rotate the Counterweight until the tonearm achieves a neutral balance The tonearm

should return to this balanced position if it is moved up or down. This adjustment must be done

carefully.

4. Once the tonearm is correctly balanced, return the tonearm to the tonearm rest and lock the

Clip.

5. While holding the counterweight steady without any rotation, rotate carefully only the Downforce

Scale Dial until the “0” on the scale lines up with the centerline marked along the top of the

tonearm.

6. Rotate the counterweight including the downforce scale dial couner-clockwise (as seen from the

front of the turntable) until the scale shows the recommended pressure value for stylus.

Note: Each mark on the scale represents 0.05g. The recommended tracking force for the factory-

installed cartridge is 3.5g 土 0.5g.The cartridge tracking force only goes up to 2g for one rotation

of the tracking force dial. You will need to make more than one rotation to reach 3.5g.