Instruction Manual Model No.
IMPORTANT SAFETY INSTRUCTIONS CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN This symbol indicates that there are important operating and maintenance instructions in the literature accompanying the unit. This symbol indicates that dangerous voltage constituting a risk of electric shock is present within the unit. 1. Read these instructions carefully. 2. Keep these instructions for futurereference. 3. Take careful note of allwarnings. 4. Follow all instructions carefully. 5.
Do not open the cabinet as this might result in damage to the circuitry or electrical shock. If any object should get into the unit, contact your dealer or service company. When removing the power plug from the wall outlet, always pull directly on the plug, not the power cord. To keep the stylus pickup clean, do not touch it, and always replace with the protective cover. Do not attempt to clean the unit with chemical solvents as this might damage the finish. Use a clean damp dry cloth.
LOCATION OF CONTROLS 10. 11. 12. 13. 14. 15. 16. 17. 18. DC 5V power jack 19. Line out R channel 20. Line out L channel 4 1. Dust cover 2. 45RPM record adapter 3. Auto stop switch(ON/OFF) 4. Speed switch(33 1/3,45,78RPM) 5. Cartridge 6. Headphone jack 7. Power ON/OFF/Volume control knob 8. Turntable platter 9.
INITIAL SET-UP MAINS CONNECTION Ensure that the mains voltage of your home corresponds to the operating voltage of the unit. Your unit is ready to be connected to a mains voltage of DC 5V adaptor. AMPLIFIER CONNECTION (if required) Whilst you can listen to your new turntable using the built in speakers you may wish to connect it to your existing HiFi system. Connect the audio plugs to the Line input on your mixer or amplifier using an RCA cable (not supplied). Red plug into “R” channel input.
PLATTER AUTO-STOP If the Auto-stop switch is set to ON position, the platter will stop spinning automatically when the record plays to the end. In some rare occasion, if the turntable stops playing before the end of the record, set the switch to OFF position the turntable should overcome this issue. BLUETOOTH FUNCTION 1. Turn on the power switch ⑦, press M ⑭ button to switch into Bluetooth mode, “bt”Alphabet will be displayed ⑯. 2.
FM FUNCTION 1. Turn on the power switch ⑦, press M ⑭button to switch into FM mode, “87.5” alphabet will be displayed ⑯. 2. Press for a few seconds ⑫ button to automatically search FM radio from 87.5 to 108Mhz. The tracks will be saved as P01, P02, P03 ... when the scanning has finished, and if the signal strength is good, the unit will automatically store 20 of the strongest pre set stations. 3.
Caution! Do not remove or bend the stylus. To avoid injury, do not touch the needle. Turn off the unit's power before you replace the stylus. Keep out of the reach of children. Handle with care, as the stylus is delicate. Use of a bent or broken stylus may damage the record and cause the turntable stylus to malfunction. Do not expose stylus to extreme heat. Contact a qualified repair company if you experience difficulty in changing the stylus.
Troubleshooting PROBLEM POSSIBLE CAUSE REMEDY GENERAL Volume not adjusted. No sound in general. The unit does not reset to operation of any button PHONO No sound when playing vinyl records The sound is breaking up or buzzing. Source mode in wrong position. Power cable disconnected or loose. Under the influence of electrostatic phenomenon, the product may malfunction and require user to disconnect.
MAIN FEATURES Bluetooth connectivity Built-in 2 Speakers Plays 3 speeds: 33 1/3, 45 and 78 RPM records LED display panel USB/TF card player USB/TF card encoding / Recording Auto-stop on/off switch High Quality cartridge and stylus included 3.5mm Aux in 3.5mm headphone jack RCA audio out FCC Statements This device complies with part 15 of the FCC Rules.
