User's Manual

Installation and Adjusting
Installation and Adjusting
Cleaning Method
Before cleaning, you must make sure that you have
unplugged the power plug.
Do not use insecticides or other volatile chemicals on
the projector or lens. Do not use rubber or vinyl products
to touch the projector. This can damage or cause coating
peel off.
Clean the Projector
Wipe with a soft dry cotton cloth. use a soft cloth dipped
in a diluted neutral detergent to wipe it, then with a dry cloth.
If you use chemical fiber cloth, please follow the precautions.
Do not use thinner, benzene or other solvents to avoid
quality degradation or peeling of the spray coating.
When cleaning the dirt, you can insert a brush in the front
of the vacuum cleaner, avoid directly use the vacuum
cleaner without any connectors or the nozzle, avoid
scratches.
Dust cleaning of lens
Use the same method to clean the camera lens, use the
professional hair dryer for the camera or the cleaning paper
for the glasses lens. Be careful not to scratch the lens.
Dust cleaning at suction and outlet
The dust in the air inlet and outlet prevents ventilation,
which will increase the internal temperature and cause
malfunctions. Cleaning guidelines: at least clean once use
every 10,000 hours.
Turn off the projector, disconnect the power.
Clean the exterior with an electric vacuum cleaner, and
install a brush head adapter on the vacuum cleaner. Please
be careful not to use a vacuum cleaner without an adapter
or brush head.
Thanks for reading!
Enjoy your time with this projector!
Play content
Turn on the projector, insert the USB disk ,
and press the remote to choose the type choose
the type of the file to play, press "OK" to enter,
select the file to play.
ABCD
Projector installation
You can choose horizontal placement
choose horizontal placement
Adjust the focus
blur Image
Focus: When the image is
blurred (as shown on the right),
adjust the focus ring to obtain
a satisfactory image imaging
effect. If you cannot obtain satisfactory
clarity through adjustment, please move
the product forward or backward as
appropriate.
Projection Distance Reference
Projection distance
Projection size
(inch)
Projection size
W*H
(m)
Projection distance
(m)
36 inch
56 inch
66 inch
86 inch
96 inch
116 inch
H0.47m W0.80m
H0.75m W1.33m
H0.87m W1.55m
H1.20m W2.13m
H1.05m W1.86m
H1.49m W2.66m
1.1m
1.7m
2.0m
2.5m
2.8m
3.4m
Safety Power Off
Press the " " button on operation panel twice
or the remote control " ", turn off the
device according to the system
prompts.
Put the dust-proof lens cover
into the lens and store the
device in a dry and cool place.
Focus ring
Home page
Due to the continuous improvement of the
design, the software interface may be slightly
different from the one shown in this figure,
please refer to the actual product.
AirPlay page
Warning Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.