User's Manual

11
Basic Operation
Start Up
 Power the interactive panel with a 100-240V 50/60Hz AC power supply.
 Connect the panel to the power supply. Switch on the rocker switch (on the left of the rear of the panel,
next to the power cable port) to enter the standby status. The power LED turns red.
 Press Power on the control panel or Standby on the remote controller to turn on the interactive panel.
The OPS computer is started. The power LED turns green.
Shutdown
 Press PC Power to turn off the OPS computer (for all-in-one models only).
 Press Power on the control panel or Standby on the remote controller to enter the standby status. The
power LED turns red.
 Under the standby status, switch off the rocker switch to turn off the interactive panel.
Note:
1] Please turn off the OPS computer before the interactive panel. Otherwise, the computer can be damaged.
2] Please disconnect the interactive panel from power after the panel enters standby status. Otherwise, the
panel can be damaged. A sudden power failure can damage the interactive panel.