User's Manual

Network

Click Network to show the network status, LAN, and agency settings. Choose a network connection method

and set parameters accordingly.

 LAN setting

If the panel is connected with LAN cable and supports Dynamic Host Configuration Protocol (DHCP),

the system will automatically configure the network protocol (IP) value.

If you want to manually set the network protocol, enter the IP address, default gateway, and DNS server

parameters on the software keyboard or remote controller. Slide / to select the subnet mask to be

changed. After setting, click < on the upper left corner or Back on the remote controller to go back to the

parent menu. Click × to close the current page.

If you select an AP with safety authentication, you need to enter the password on the software keyboard on the

safety authentication interface.

After setting, click < on the upper left corner or Back on the remote controller to go back to the parent

menu. Click × to close the current page.