FCC INFORMATION: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules.These limits are designed to provide residential protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
Location of Controls 1. MIC (Microphone) 4. Indicators 2. LINE IN Jack 5. Button 3. DC IN Jack 8. Toggle Switch Battery Recharge: The unit has a built-in Li-ion rechargeable battery, recharge it before use or when the battery is consumed as follow: 1. Connect the small plug from the supplied USB Connection Cable to the DC IN Jack (Micro USB Port) on the unit. 2. Connect the other plug to the USB Port on the Computer or any USB Charger having DC 5V output (Computer and USB Charger not included). 3.
Notes: Your battery will last longer if you follow these simple guidelines for charging and storing it. A. Before first time use, charge the unit approximate 2 hours until the unit is fully charged. B. Recharge and store the device within the temperature range of C. Do not overcharge { longer than 24 hours }. Excessive charging or discharging may shorten the battery's life. D. Battery life naturally shortens slowly over time. E. The rechargeable battery incorporated in this product is not replaceable.
© 4. During playback: ® Press the Toggle Switch to pause; press again to resume normal playback. ® Slide the Toggle Switch to front {or rear} and hold to adjust the volume level as desire. ® Slide the Toggle Switch to front (or rear) then release to skip tracks. Repeat the same procedures until the desired tracks was selected and play. 5. If the unit is paired to a cell phone. When a call is incoming, press the Toggle Switch to hook off then speaker to the MIC (Microphone) to answer the phone.
Troubleshooting: The built-in batch Can't be power on a lanolin hart ry Recharge the battery. Slide the Toggle Switch No sound Volume was set to to front for rear) and hold minimum level. to adjust the volume level as desire. Slide the Toggle Switch | i o front (or rear) and hol Sound distortion Volume level too high. to bluet the volume level as desire. Paired the External BT Device to the unit as previous procedures. The Textual BT Device had not paired to the unit.
@| © Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
LIMITED WARRANT Craig warrants this product to be free from manufacturing defects in material and workmanship under normal use for a period of 90 days from date of purchase. If service is required, please return the product fo the store where it was purchased for exchange; or, pack the unit in the original packing material with all accessories if applicable, a copy of your sales receipt and a Cashier's check or Money Order for $3.00 (to cover shipping and handling costs) payable to Craig Electronics Inc.
