FCC NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
LOCATION OF CONTROLS: Charging Station: 1. 2. 3. 4. 5. Power On/Off Button Charging port for L (Left) Earbud Charging port for R (Right) Earbud LED Indicators Cover 6. Micro USB Port (For charger only) Earbuds: 1. 2. 3. 4.
POWER SOURCE: The Charging station and Earbuds equipped built in Li-ion rechargeable battery; recharge it before use or when it is drained as follows: Charging Station: 1. Connect the Micro USB Plug from the supplied USB Connection Cable to the Micro USB Port on the rear of Charging Station. 2. Connect the full sized USB Plug from the supplied USB Connection Cable to the USB Port on the Computer or USB Charger. (Computer and USB Charger NOT 3. supplied).
Notes: 1. During charging the Charging Station, you can also charge the Earbuds through it at the same time. 2. Your battery will last longer if you're following these simple guidelines for caring and storing. A. Before first time use, charge the Charging Station and Earbuds approximately 0.5 hour until there is fully charged. B. Recharge and store the Charger and Earpieces within the temperature range of 5°C~35°C (40°F~95°F). C. D. E. Do not charge longer than 24 hours.
OPERATION: STEREO MODE: BT (Bluetooth) pairing: To pair the R & L Earbuds to the BT Device in stereo mode for the first time (or repair to a new BT Device), follow the steps below: 1. Power on the R & L Earbuds by pressing the Button on each Earbud at the same time. Then: The Red & Blue Indicators on the R Earbud will illuminate and blink. The Blue Indicator on the L Earbud will illuminate and blink. 2. 3. 4. 5. 6. 7. Power on the external BT Device and enter to BT searching mode.
3. If R Earbud is using, the Red Indicator on it will turn off. If L Earbud is using, the blinking frequency of Blue Indicator will slow down. (The Red Indicator on the R Earpiece will not light.) After pairing is complete you may now play music and answer calls with your external BT Device. MONO MODE: BT (Bluetooth) pairing: To pair R (or L) Earbuds to the BT Device in mono mode for the first time (or repair to a new BT Device), follow the steps below: 1.
Notes: When the external BT Device searched the unit, our model number “MBH530” will appear on the display of external BT Device. If while pairing you are asked for a code please try "0000" or "1234". Normal operation after pairing: 1. Power on the R (or L) Earbud by pressing the Button on it. 2. If R Earbud is using, the Red & Blue Indicators on it will illuminate and blink. If L Earbud is using, the Red & Blue Indicators on it will illuminate and blink.
TROUBLESHOOTING Check the following before requesting service: SYMPTOM Can’t power on POSSIBLE CAUSE Built in battery drained POSSIBLE SOLUTION Recharge the built-in battery of Charging Station and Earbuds as page 3-4 The Earbuds can The Power On/Off Button on the Charging NOT be recharging Station is in Off position Press the Power On/Off Button on the Charging Station until the Blue LED Indicator is illuminate The Charging contacts on the Charging Clear it before charging Station and/or Earbud is
PACKAGE INCLUDES: 1 x User’s Manual 1 x Charging Station 2 x Earbuds 1 x USB Connection cable (For charging the Charging Station only) SPECIFICATIONS AND ACCESSORIES ARE SUBJECT TO CHANGE WITHOUT NOTICE
