User's Manual

7. Warning

Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority

to operate the equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device

may not cause harmful interference, and (2) this device must accept any interference received, including interference that may

cause undesired operation

SAR Information

The SAR limit of USA (FCC) is 1.6W/kg Averaged over one gram of tissue. Device types GSM/GPRS Mobile Phone (FCC

ID : XUT-W007) has also been tested against this SAR limit. This device was tested for typical body-worn operations with the

back of the handset kept 1.5cm from the body. To maintain compliance with FCC RF exposure requirements, use accessories

that maintain a 1.5cm separation distance between the user’s body and the back of the handset. The use of belt clips, holsters and

similar accessories should not contain metallic components in its assembly. The use of accessories that do not satisfy these

requirements may not comply with FCC RF exposure requirements, and should be avoided.

Specific Absorption Rate Data

This Model wireless phone meets the government’s requirements for exposure to radio waves.

Your Mobile phone is a radio transmitter and receiver. It is designed and manufactured to exceed limits for exposure to radio

frequency (RF) energy set by the Federal Communication Commission (FCC) of the U.S Government. These limits are part of

comprehensive guidelines and establish permitted levels of RF energy for the general population. The guidelines are based on

standards that were developed by independent scientific organizations through periodic and thorough evaluation of scientific

studies. The standards include a substantial safety margin designed to assure the safety of all persons regardless of age or health.

The exposure standard for wireless mobile phones employs a unit of measurement known as the Specific Absorption Rate, or

SAR, The SAR limit set by the FCC is 1.6 W/Kg. Tests for SAR are conducted using standard operating positions accepted by

the FCC with the phone transmitting at its highest certified power level in all tested frequency bands. Although the SAR is

determined at the highest certified power level, the actual SAR level of the phone while operating can be well below the

maximum value. This is because the phone is designed to operate at multiple power levels so as to use only the power required

to reach the network. In general, the closer you are to a wireless base station, the lower the power output.

Before a phone model is available for sale to the public in the U.S, it must be tested and certified to the FCC that it does not

exceed the limit establish for safe exposure. The tests are performed in positions and locations (e.g, at the ear and worn on the

body) reported to the FCC.

While there may be differences between the SAR levels of various phones and at various positions, they all meet the

governmental requirements for safe exposure. Please note that improvements to this product model could cause differences in

the SAR value for later products, in all cases, products are designed to be within the guidelines.

Additional information on Specific Absorption Rates (SAR) can be found on the Cellular Telecommunications & Internet

Association (CTIA) Web site:

http://www.phonefacts.net

In the United States and Canada, the SAR limit for mobile phones used by the public is 1.6 W/Kg averaged over one gram of

tissue. The standard incorporates a substantial margin of safety to give additional protection for the public and to account for any