Frequently Asked Questions


 10/13

pointingtoeachotherandbyhavingenoughdistanceorbarriershieldinginbetween
them.Thesignalstravellikeraysofsunlight,adirectionalantennawillsendthesignal
inthedirectionthatitispointing.Anomnidirectionalantennawillsendthesignalin
everydirectionaroundit.Sodepending onyourequipmentit’simportanttobesure
thatyourIndoorantennaisnotsendingthesignalbackintotheoutdoorantenna.
THINGSTOCHECKWHENEXPERIENCINGWEAKCELLULARSIGNAL
1. Checkallconnectionsonthecable,antennas,andbooster.
2. Checkcableforbendsandorcuts. 
3. AllLEDlightsontheboostershouldbeblue.
4. Outdoor antenna and the indoor antennas have adequate separation and are
notcausingfeedback.
5 FREQUENTLYASKEDQUESTIONS
WHY ARE THE LED LIGHTS TURNING FLASHING GREEN, FLASHING
REDORSHUTTINGOFF?
There are certain cases where your system could be experiencing
oscillation.Thiscanbeattributedtoeitherthequalityofyourinputsignal
or having your outdoor antenna and indoor antenna too close together. Please
reviewthefollowingguidelinestohelpresolvethisissue:
1. Adjustthedirectionoftheoutdoorantenna.Ifthesystemisreceivingaveryhigh
inputsignal,youcanpointyouroutdoorantennaawayfromthecellulartowerto
reduce the strength of the input signal and therefore, reduce the oscillation.
Alternatively if your system is receiving a very poor quality signal (weak and
unusablesignal),youcanhightheantennatoincreasethestrengthoftheinput
signal. Sometimes this may require completely repositioning the antenna to a
locationwhereyoucanachievealineofsitetothetower.
2. Increasetheseparationbetweentheoutdoorantennaandthe indoor antenna.
Thiscanbeachievedbyincreasingthedistancebetweenthetwoantennasorby
placingbarriersbetweenthem.
6 FCCRFExposureStatement
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. End users must follow the specific  operating instruction
for satisfying RF exposure compliance. This equipment should be installed and
operatedwithminimumdistance20cmbetweentheradiator&yourbody.
This transmitter must not be co‐located or
 operating in conjunction with  any other
antennaortransmitter. 



