User's Manual

10/20
•Keep horizontal cables straight and fasten them with a tie every three to five feet.
•Bind and fasten vertical cables every six to eight feet.
•Waterproof all connectors between outdoor antenna and coaxial cables with
waterproof tape to avoid water or other kinds of damage.
•Be careful when plugging the connector in so as not to damage the center pins on
the connectors.
1.9 Power up your signal booster
Once all the following precautions have been taken, power on the signal booster.
1.Verify that you have left at least 1m of vertical separation space between the indoor
and outdoor antennas.
2.Never point the front of outdoor antenna towards the inside of the indoor antenna.
3.Verify that the supplied coaxial cables from both the outdoor antenna and the indoor
antenna are properly connected to the signal booster before powering it up.
4.Carefully plug in the supplied power adaptor into the signal booster where it is marked
'DC IN' and connect the other end to a power outlet.
The LED indicator marked power should light up green.
SIGNAL BOOSTER STATUS
Overview: The booster has a smart startup system. When you have finished the booster
system installation and power on the booster, it will start its initialization process to
check the received downlink signal from the cell site and the isolation status. This an
automatic process designed to ensure its best performance. This will take approximately
3-5 seconds.
After the booster starts up, please check if the coverage is good. If it is good, the booster
system installation is complete. If the coverage is not adequate, please fully reread and
understand the LCD, LED indications, control buttons, and MGC function on your
booster. These will help you identify and solve any potential issues.