User's Manual

1.7 Install your signal booster
The signal booster should be mounted in an easily accessible area so it's easy to perform
general maintenance. The area is properly ventilated and not exposed to excessive heat,
moisture and/or direct sunlight. The optimal area would be on a wall located near a power
outlet. Please use a surge protector rated at a minimum of 1000 Joules between the
booster's power adaptor and the AC power outlet on the wall.
Mount the booster with the included screws as shown in the figure below.
1.8 Run coaxial cable
Loosely run the supplied coaxial cable from your outdoor antenna to your booster
connector marked "Outdoor." We recommend applying waterproof tape to fully waterproof
the connection
Connect the indoor antenna cables from your indoor antenna to the booster connector
marked "Indoor." Tighten the connection by hand.
(After you have tested the system you can permanently secure the coaxial cable).
As you route and pull cabling, follow these general guidelines:
• Bend cables and route them smoothly, and protect the outer skin against any damage.
9/20