User's Manual

User Manual
- 18 -
of power and alarm LEDS, and three system Boosters have three sets of LEDS. Each system has
own relevant LED and please refer to the correct LED for system performance evaluation.
Then Booster with plastic closet is designed with LEDS of “Alarm LOW” and “Alarm HIGH”. When it is
used for single system of CDMA800, GSM850 and GSM900, only “Alarm Low” LED works, and
“Alarm HIGH” LED is no use; when it is used for single system of DCS, PCS, CDMA1900, WCDMA or
AWS, “Alarm HIGH” LED works, and “Alarm LOW” LED is no use. When the Booster supports two
systems, “Alarm Low” and “Alarm HIGH” both work and support relevant low and high frequencies.
9.3.2. Manual Gain Control (MGC)
DIP Switch can be used to adjust the Booster gain when Alarm LED is orange or even RED. The principle is
that Booster alarm LED must be green color.
 For F15C-CP-M:
Switches 1-4 represent Downlink and 4.8
represent Uplink. When it is necessary to
adjust the gain by DIP switch, firstly please
adjust Downlink gain according to input
signals, secondly please adjust Uplink gain
according to Downlink gain.
The DIP Switches have default ‘OFF’ status;
please push relevant switches to “ON”
position if certain attenuation value needs to
be achieved.
z DIP switch attenuation setting:
Att 1 2 3 4 Att. 1 2 3 4 Att. 1 2 3 4
0 dB off off off off 6 dB off ON ON off 12dB off off ON ON
1 dB ON off off off 7 dB ON ON ON off 13dB ON off ON ON
2 dB off ON off off 8 dB off off off ON 14dB off ON ON ON
3 dB ON ON off off 9 dB ON off off ON 15dB ON ON ON ON
4 dB off off ON off 10dB off ON off ON
5 dB ON off ON off 11dB ON ON off ON